1. Home
  2. Products
  3. Workstation Conveyor and Assembly Line
  4. PCB Workstation Conveyor
  5. Individual Worktable Manual Soldering Conveyor

Individual Worktable Manual Soldering Conveyor, 18-25 meters

Work Table Conveyor, Conveyor Workstation, PCB Assembly Line

Drive motor
2HP Toho horizontal gearbox

Work table
400mm×600mm, make δ18mm wood plate as raw material, covered with anti-static rubber and T-shaped binding tape. The support utilizes 30×30 mm square steel. The work table is 720±20mm high

Attractive Features
Drive system
1. Both ends are manufactured from square steel. It's of high stability and fastens the motor.
2. The speed regulator realizes a processing speed of 0-6 meters per minute, with little noise.

Machine Design
1. The support makes use of 40mm×40mm square steel and the work stable is 750±20mm.
2. Each part of this material handling equipment is connected by standard screws, which is easy to disassemble, stable and hard to deform. Plus, the disassembly does no harm to the screw.
3. The beams are produced from 40×60 mm aluminum square tubes, with no harm to the electronic products.
4. The conveyor belt is imported from Netherland, allowing for seamless connection and anti-static capacity.
5. In order for smooth material transfer, galvanized plates are used below the conveyor belt and rollers are installed every meter in the conveyor.
6. In the power supply system, galvanized trunking and 4mm2 power line are used. Additionally, multiple outlet is mounted every meter in the system.
7. Above the lamp bracket, two aluminum beams are installed with gliders.
8. T5 18W LED lights are installed on both sides for lighting.

Inquiry Form